Transmission Fluid Pressure Switch C (4th Clutch) Replacement

WARNING: This page is about a different variant/trim than selected.

Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
Remove the front splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
Disconnect the transmission fluid pressure switch C (4th clutch) connector, and remove transmission fluid pressure switch C (4th clutch) and the sealing washer (A).

Fig 1: Transmission Fluid Pressure Switch And Sealing Washer With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new transmission fluid pressure switch C (4th clutch) with a new sealing washer, and tighten the switch.
Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
Install the front splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).