Transfer Output Shaft (Hypoid Gear) Bearing Removal/Installation

Special Tools Required 

Driver Handle, 40 mm I.D. 07746-0030100

1. Remove the tapered roller bearing (A) from the transfer output shaft (hypoid gear) (B) using a bearing separator (C) and a press. Place a spacer (D) between the transfer output shaft and the press to prevent damaging the transfer output shaft.
   Fig 1: Removing Tapered Roller Bearing From Transfer Output Shaft Using Bearing Separator

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the 40 mm thrust shim (A) over the transfer output shaft (hypoid gear).
   Fig 2: Installing Thrust Shim Over Transfer Output Shaft

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the tapered roller bearing over the transfer output shaft (hypoid gear) using the 40 mm driver I.D. handle and the press.