Transfer Housing Tapered Roller Bearing Outer Race Replacement

Special Tools Required 

• Driver Handle, 15 x 135L 07749-0010000
• Bearing Driver Attachment, 52x55 mm 07746-0010400
• Oil Seal Driver Attachment, 65 mm 07JAD-SH30100
• Tapered Bearing Race Installer A 07MAF-SP0011A
• Installer Shaft 07MAF-SP0013A

1. Remove the 52 mm tapered roller bearing outer race (A), the 75 mm tapered roller bearing outer race (B), and the 65 mm tapered roller bearing outer race (C) from the transfer housing (D).
   NOTE: Some tapered roller bearing outer races (52 mm, 65 mm, and 75 mm) are press-fitted in the transfer housing and must be removed by heating the transfer housing.
   Fig 1: Identifying Roller Bearing Outer Races And Transfer Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the press-fitted tapered roller bearing outer race (A) from the transfer housing (B) by heating the transfer housing to about 212°F (100°C) using a heat gun (C). Do not heat the transfer housing more than 212°F(100°C).
   Fig 2: Removing Press-Fitted Tapered Roller Bearing Outer Race By Heating Using Heat Gun

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install a new 52 mm tapered roller bearing outer race (A) until it bottoms in the transfer housing (B) using the 15 x 135L driver handle and the 52 x 55 mm bearing driver attachment.
   Fig 3: Installing Tapered Roller Bearing Outer Race Using Driver Handle And Bearing Driver Attachment

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install a new 75 mm tapered roller bearing outer race (A) and a new 65 mm tapered roller bearing outer race (B) in the transfer housing (C), set the 65 mm oil seal driver attachment and tapered bearing race installer A over the tapered roller bearing outer races, and install the installer shaft through the 65 mm oil seal driver attachment and installer.
   Fig 4: Identifying Roller Bearing Outer Race, Tapered Roller Bearing Outer Race And Transfer Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Tighten the installer shaft nut (A) to install the tapered roller bearing outer races (B) (C) into the transfer housing (D) securely.
   Fig 5: Identifying Installer Shaft Nut, Tapered Roller Bearing Outer Races And Transfer Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.