Idler Gear Shaft Reassembly

WARNING: This page is about a different variant/trim than selected.

Install the idler gear (A) over the idler gear shaft (B).

Fig 1: Installing Idler Gear Over Idler Gear Shaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Place the idler gear (A) on press bases (B), and place a spacer (C) between the idler gear shaft (D) and the press to prevent damaging the idler gear shaft.

Fig 2: Placing Idler Gear On Press Bases And Place Spacer Between Idler Gear Shaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the idler gear using a press.
Install the 32.5 mm cotter (A), the cotter retainer (B), and the snap ring (C) on the idler gear shaft (D).

Fig 3: Identifying Cotter, Cotter Retainer, Snap Ring, Idler Gear Shaft, Thrust Needle Bearing And Washer
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the 27.5 x 41 x 2.5 mm thrust needle bearing (E) and the 41.5 mm washer (F).