LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2012 >> TL SH-AWD, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> General Troubleshooting Information >> Clear A/T DTCs Procedure

Clear A/T DTCs Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard.
    Fig 1: Identifying Data Link Connector (DLC) Location
    G08066294Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
  3. Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
  4. Clear the DTC(s) with the HDS.
scientia non olet · About LEMON Manuals