LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2012 >> TL SH-AWD, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Drive Plate Removal and Installation

Drive Plate Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly (see TRANSMISSION REMOVAL  ).
  2. Remove the drive plate (A) and the washer (B) from the engine.
    Fig 1: Drive Plate And Washer With Torque Specifications
    G08066527Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the drive plate and the washer on the engine crankshaft, and tighten the eight bolts in a crisscross pattern in at least two steps.
  4. Install the transmission assembly (see TRANSMISSION INSTALLATION  ).
scientia non olet · About LEMON Manuals