1st Gear One-Way Clutch Inspection

WARNING: This page is about a different variant/trim than selected.

Install the 53 x 57 x 20 mm needle bearing (A) and 1st gear (B) on the park gear (C).

Fig 1: Installing Needle Bearing And 1st Gear On Park Gear
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Hold the park gear (A), and turn 1st gear (B) in the direction shown to be sure it turns freely. Also make sure 1st gear locks in the opposite direction.

Fig 2: Identifying Park Gear And 1st Gear
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If any problem occurs on the 1st gear one-way clutch, replace 1st gear. The 1st gear one-way clutch is not available separately from 1st gear.