LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2012 >> TL SH-AWD, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> General Troubleshooting Information >> How to Clear DTCs

How to Clear DTCs

NOTE: Make sure the battery is fully charged before you begin.
  1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
  2. Connect the HDS to the data link connector (DLC) (A).
    Fig 1: Identifying Data Link Connector (DLC)
    G08068152Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
  4. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
  5. In the SRS MENU of the HDS, select SRS, then DTC to clear DTCs.
  6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, then wait for 10 seconds.
  7. Disconnect the HDS from the DLC.
scientia non olet · About LEMON Manuals