Passenger's Dashboard Undercover Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

* Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the passenger's dashboard undercover (A).
1. Gently pull down the rear edge of the undercover to detach the clips.
2. Disconnect the front passenger's footwell light connector (B).
3. Pull out the undercover to release the pins (C) from the brackets (D).
  
  Fig 1: Identifying Front Passenger's Footwell Light Connector, Passenger's Dashboard Undercover, Pins And Brackets
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Make sure the pins are installed securely in the brackets.
- Push the clips into place securely.