Entering the Self-diagnostic Function
Before doing the self-diagnostic function, check the No. 7 (10 A) fuse and the No. 21 (10 A) fuse in the driver's under-dash fuse/relay box.
- Push and hold the SELECT/RESET button.
- Turn the lighting switch (»◦◦«) ON.
- Turn the ignition switch to ON (II.
- Within 5 sec, turn the lighting switch (»◦◦«) OFF, then ON and OFF again.
- Within 5 sec, release the SELECT/RESET button, and then push and release the button three times repeatedly.
NOTE:
- While in the self-diagnostic mode, the dashlights brightness controller operates normally.
- While in the self-diagnostic mode, the SELECT/RESET button is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
- If the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned to LOCK (0), the self-diagnostic mode ends.