LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2012 >> RL >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Gauges >> Select/Reset/Information Switch Test/Replacement

Select/Reset/Information Switch Test/Replacement

  1. Remove the driver's airbag assembly. See DRIVER'S AIRBAG REPLACEMENT .
  2. Disconnect the 6P connector (A) from the select/reset/information switch (B).
    Fig 1: Disconnecting 6P Connector From Select/Reset/Information Switch
    G07355126Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Measure the resistance between select/reset/information switch 6P connector terminals No. 6 and No. 5 in each switch position according to the table.
    RESISTANCE SPECIFICATIONS

    Position Resistance
    ↑ About 33 Ω
    SEL/RESET About 1, 043 Ω
    ↓ About 363 Ω
  4. If the resistance is not as specified, remove the two screws, and replace the switch.
  5. If the switch is OK, but there is a problem with the switch function, check the steering switches harness and cable reel.
scientia non olet · About LEMON Manuals