Gauge Control Module Replacement

NOTE: Before replacing the gauge control module, do the "Rewriting the ODO Data and Transferring the Maintenance Minder Data to a New Gauge Control Module". See REWRITING THE ODO DATA AND TRANSFERRING THE MAINTENANCE MINDER™ DATA TO A NEW GAUGE CONTROL MODULE .

Remove the instrument fascia. See INSTRUMENT FASCIA REMOVAL/INSTALLATION .
Remove the screws from the gauge control module (A).

Fig 1: Removing Screws From Gauge Control Module
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the connectors (B), and remove the gauge control module.
Install the gauge control module in the reverse order of removal.
Rewriting the ODO data and transferring the maintenance minder data to a new gauge control module. See REWRITING THE ODO DATA AND TRANSFERRING THE MAINTENANCE MINDER™ DATA TO A NEW GAUGE CONTROL MODULE )

NOTE: Check the official Honda website for more information on how to write odometer information to a gauge control module that will not communicate with HDS.