DTC B1175: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. See TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A .

Clear the DTCs with the HDS.
Turn the ignition switch to LOCK (0), and then back to ON (II).
Wait for at least 30 seconds.
Check for DTCs with the HDS.
Is DTC B1175 indicated?

YES -Go to step 5.

NO -Intermittent failure, the gauge control module is OK at this time. Check for loose or poor connections.
Do the fuel gauge sending unit test. See FUEL FILL PIPE REMOVAL/INSTALLATION .
Is the fuel gauge sending unit OK?

YES -Go to step 6.

NO -Replace the fuel gauge sending unit.
Turn the ignition switch to LOCK (0).
Disconnect the fuel tank unit 5P connector. See FUEL FILL PIPE REMOVAL/INSTALLATION ).
Disconnect gauge control module connector A (20P).
Connect fuel tank unit 5P connector terminal No. 2 to body ground with a jumper wire.

Fig 1: Connecting Fuel Tank Unit 5P Connector Terminal No. 2 To Body Ground With Jumper Wire
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between gauge control module connector A (20P) terminal No. 19 and body ground.

Fig 2: Checking Continuity Between Gauge Control Module Connector (20P) Terminal No. 19 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Is there continuity?

YES -Go to step 11.

NO -Repair an open or high resistance in the wire.
Disconnect the secondary fuel gauge sending unit 5P connector. See FUEL FILL PIPE REMOVAL/INSTALLATION .
Connect secondary fuel gauge sending unit 5P connector terminal No. 1 to body ground with a jumper wire.

Fig 3: Connecting Secondary Fuel Gauge Sending Unit 5P Connector Terminal No. 1 To Body Ground With Jumper Wire
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between gauge control module connector A (20P) terminal No. 18 and body ground.

Fig 4: Checking Continuity Between Gauge Control Module Connector (20P) Terminal No. 18 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Is there continuity?

YES -Go to step 14.

NO -Repair an open or high resistance in the wire.
Check for continuity between fuel tank unit 5P connector terminal No. 1 and secondary fuel gauge sending unit 5P connector terminal No. 2.

Fig 5: Checking Continuity Between 5P Connector Terminal No. 1 And 5P Connector Terminal No. 2

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Is there continuity?

YES -Replace the gauge control module. See GAUGE CONTROL MODULE REPLACEMENT .

NO -Repair an open or high resistance in the wire.