The BSI indicator does not go off, or does not come on
NOTE:
- If the system malfunctions, always check for DTCs with the HDS.
- If a DTC is stored, troubleshoot the DTC first.
- Turn the ignition switch to ON (II), then wait for 10 seconds.
- Check that the BSI indicator comes on for about 2-5 seconds and then goes off.
Does the BSI Indicator go off?
YES -The system is OK.
NO -Go to step 3.
- Check for DTCs with the HDS (see General Troubleshooting Information
).
Are any DTCs Indicated?
YES -Troubleshoot the indicated DTC(s).
NO -Go to step 4
- Do the gauge control module self-diagnostic function (see
SELF-DIAGNOSTIC FUNCTION
).
Does the side BSI indicator flash?
YES -Replace the BSI control unit
NO -Replace the gauge control module, and recheck.