Grab Handle Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program 888-424-6857

NOTE:

Take care not to scratch the grab handle or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
When prying with the flat-tip screwdriver, wrap it with protective tape to prevent damage.

Lower the grab handle (A), then insert a small flat-tip screwdriver wrapped in protective tape into the notch.

Fig 1: Inserting Small Flat-Tip Screwdriver Wrapped In Protective Tape Into Notch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull on the small flat-tip screwdriver with the appropriate trim tool (A), and remove the cap (B).

Fig 2: Pulling Small Flat-Tip Screwdriver With Appropriate Trim Tool And Cap
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pinch the clips (A), release the hooks (B), then remove the grab handle (C).

Fig 3: Identifying Grab Handle, Pinch Clips And Release Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pinch the hooks on the clips (A) with a pair of pliers, and pull out the clips.

Fig 4: Pinching Hooks On Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the side curtain airbag has deployed, replace the grab handle with a new one.
If the side curtain airbag has not deployed, inspect the grab handle for damage. A damaged grab handle may cause the side curtain airbag to deploy improperly, possibly causing injury. Replace the grab handle if it has any of the following damage:
- Any cracks or damages in the grab handle (A).
- Any cracks or stress-whitening in the caps (B).
  
  Fig 5: Identifying Grab Handle And Caps
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the clips (A) to the grab handle (B), then install the caps (C) fully into the clips.

Fig 6: Installing Clips To Grab Handle
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Position the grab handle (A) on the mounting bracket (B), and push on the grab handle until the clips (C) snap into place securely.

Fig 7: Identifying Grab Handle On Mounting Bracket
Courtesy of AMERICAN HONDA MOTOR CO., INC.