Front Bulkhead Cover Replacement

NOTE:

Take care not to scratch the front bumper or the body.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Remove the front bulkhead cover (A).
1. Remove the clips.
2. Pass the hood latch knob (B) through the hole in the cover.
  
  Fig 1: Identifying Front Bulkhead Cover Fastener Location
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.