Tailgate Weatherstrip Replacement

Remove the left tailgate side trim (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
Remove the pivot bracket mounting bolts, then push the power tailgate rod (A) in the quarter pillar trim (B).

Fig 1: Pushing Power Tailgate Rod In Quarter Pillar Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the tailgate weatherstrip (A) by pulling it out.

Fig 2: Locating Tailgate Weatherstrip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Locate the painted alignment mark (A) on the tailgate weatherstrip (B). Align the painted mark with the alignment notch in the center of the tailgate opening, and install the tailgate weatherstrip all the way around. Slip the weatherstrip in under the lips (C) of both rear gutter covers (D). Make sure there are no wrinkles in the weatherstrip.

Fig 3: Locating Painted Alignment Mark On Tailgate Weatherstrip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fasten the pivot bracket (A) on the tailgate.

Fig 4: Pivot Bracket With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the left tailgate side trim (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
Check for water leaks (see step 9 under DOOR GLASS ADJUSTMENT