Center Console Rear Trim Disassembly/Reassembly

Special Tools Required 

KTC Trim Tool Set SOJATP2014*

* Available through the Acura Tool and Equipment Program, 888-424-6857

1. Remove the center console rear trim (see CENTER CONSOLE REAR TRIM REMOVAL/INSTALLATION  ).
2. Remove the screws, then remove the center console duct (A).
   Fig 1: Identifying Center Console Duct And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the screws and release the hooks (A), then remove the HVAC trim (B).
   Fig 2: Identifying HVAC Trim, Hooks And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the screws, then remove the rear upper lid (A).
   Fig 3: Identifying Rear Upper Lid And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Remove the screws and detach the clips (A, B), then remove the rear console vent/vent trim (C).
   Fig 4: Identifying Rear Console Vent/Vent Trim Screws And Clips

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the screws, then remove the rear console vent (A) from the rear console vent trim (B).
   Fig 5: Identifying Rear Console Vent, Rear Console Vent Trim And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Without rear entertainment: Remove the screws and release the hooks (A), then remove the accessory power socket panel (B).
   Fig 6: Identifying Accessory Power Socket Panel, Hooks And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Reassemble the rear trim in the reverse order of disassembly, and note these items:
   • If the clips are damaged or stress-whitened, replace them with new ones.
   • Push the clips and the hooks into place securely.