Passenger's Dashboard Undercover Removal/Installation

NOTE: Take care not to scratch the dashboard or the related parts.

Remove the passenger's dashboard undercover (A).
1. Gently pull down the rear edge to detach the clips.
2. Disconnect the footwell light connector (B).
3. Pull the undercover away to release the pins (C) from the holders (D).
  
  Fig 1: Identifying Passenger's Dashboard Undercover And Clips
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Make sure the pins of the undercover are installed securely to the holders.
- Push the clips into place securely.