Instrument Fascia Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove these items:
- Driver's outer dashboard trim (see DRIVER'S OUTER DASHBOARD TRIM REMOVAL/INSTALLATION )
- Driver's inner dashboard trim (see DRIVER'S INNER DASHBOARD TRIM REMOVAL/INSTALLATION )
Adjust the steering column to the full tilt down position, and to the full telescopic out position.
Detach the clips and release the hooks (A) fastening the instrument fascia (B) from the upper column cover (C).
NOTE: Make sure you do not damage the fabric.

Fig 1: Identifying Upper Column Cover, Hooks And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Gently pull out the bottom to detach the clips, and disconnect the dashlights brightness controller switch connector (A), then remove the instrument fascia (B).

Fig 2: Identifying Dashlights Brightness Controller Switch Connector, Instrument Fascia And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the instrument fascia in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips and the hooks into place securely.