Removal (with SH-AWD)

Special Tools Required 

Fuel sender wrench 07AAA-S0XA100

1. Relieve the fuel pressure (see FUEL PRESSURE RELIEVING )
2. Remove the rear seat cushion (see REAR SEAT REMOVAL/INSTALLATION )
3. Remove the access panel (A) from the left side of the floor
   Fig 1: Identifying Access Panel And Fuel Tank Unit 4P Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Disconnect the fuel tank unit 4P connector (B)
5. Disconnect the quick-connect fitting (C) from the fuel tank unit
6. Using the special tool, loosen the locknut (A)
   Fig 2: Identifying Locknut

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Remove the locknut (A), and lift up the fuel tank unit(B)
   Fig 3: Identifying Fuel Tank Unit And Locknut

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Disconnect the transfer tube (C), and remove the fuel tank unit