Passenger's Dashboard Undercover Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the Acura Tool and Equipment Program, call 888-424-6857
NOTE:
- Take care not to scratch the dashboard or its related parts
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components
- Remove the passenger's dashboard undercover (A)
- -1 Gently pull down the rear edge to detach the clips
- -2 Pull the undercover away to release the pins (B) from the brackets (C)
- -3 Disconnect the front passenger's footwell light connector (D)
- Install the undercover in the reverse order of removal, and note these items
- If the clips are damaged or stress-whitened, replace them with new ones
- Push the clips into place securely
- Make sure footwell light connector is plugged in properly
- Make sure the pins are installed securely in the brackets