Driver's Dashboard Undercover Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Acura Tool and Equipment Program, call 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components

Remove the driver's dashboard undercover (A)
1. -1 Turn the lock knob (B) 90°
2. -2 Gently pull down the rear edge to detach the clip
3. -3 Disconnect the footwell light connector (C) and the harness clip (D)
4. -4 Pull the undercover rearward to release the brackets (E) from the pins (F)
Fig 1: Identifying Footwell Light Connector, Brackets And Pins
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items
- If the clip is damaged or stress-whitened, replace it with a new one
- Push the clip into place securely
- Make sure the footwell light connector is plugged in properly
- Make sure the brackets are installed securely on the pins