Entering the self-diagnostic function (manual method)
Before doing the self-diagnostic function, make sure the No 12 (7.5 A) fuse in the driver's under-dash fuse/relay box and the No 15 (10 A) fuse in the under-hood fuse/relay box are OK
- Push and hold the SEL/RESET button
- Turn the combination light switch ON
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Within 5 sec, turn the combination light switch OFF, then ON and OFF again
- Within 5 sec, release the SEL/RESET button, and then push and release the button three times repeatedly
NOTE:
- While in the self-diagnostic mode, the dash lights brightness controller operates normally
- While in the self-diagnostic mode, the SEL/RESET button is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check
- If the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned to LOCK(0), or the vehicle is in OFF mode, the self-diagnostic mode ends