Panoramic Glass Roof Edge Protector Replacement

Panoramic Glass Roof Edge Protector Replacement

1. Remove the moving glass panel Service and Repair.

2. Remove the edge protector (A) from the moving glass panel (B).






3. Scrape off the remaining adhesive from the moving glass panel, then clean the panel bonding surface with a sponge dampened in isopropyl alcohol. After cleaning, do not allow oil, grease, and water to contact the clean surface.

4. Apply glass primer to the area of the moving glass panel where the new edge protector will be attached. Attach the protector with the adhesive along the front edge of the panel, then push on the adhesive area to make adhesive stick securely.

5. Reinstall the moving glass panel Service and Repair.