The BSI Indicator Does Not Go Off, or Does Not Come On

Blind Spot Information System (BSI) Symptom Troubleshooting - The BSI indicator does not go off, or does not come on

The BSI indicator does not go off, or does not come on

NOTE:

- If the system malfunctions, always check for DTCs with the HDS.
- If a DTC is stored, troubleshoot the DTC first.

1. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.

2. Check that the BSI indicator comes on for about 2-5 seconds and then goes off.

Does the BSI indicator go off?

YES -

The system is OK.�

NO -

Go to step 3.

3. Check for DTCs with the HDS How To Troubleshoot The Blind Spot Information System (BSI).

Are any DTCs indicated?

YES -

Troubleshoot the indicated DTC(s).�

NO -

Go to step 4.

4. Do the gauge control module self-diagnostic function Initial Inspection and Diagnostic Overview.

Does the side BSI indicator flash?

YES -

Replace the BSI control unit BSI Control Unit Removal/Installation.�

NO -

Replace the gauge control module Service and Repair, and recheck.�