Communication Circuit Error (Bus-Off)

DTC Troubleshooting: U1280

DTC U1280:

Communication Circuit Error (BUS-OFF)

1. Clear the DTCs with the HDS How To Troubleshoot The Blind Spot Information System (BSI).

2. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.

3. Check for DTCs with the HDS How To Troubleshoot The Blind Spot Information System (BSI).

Is DTC U1280 indicated?

YES -

Replace the BSI control unit BSI Control Unit Removal/Installation.�

NO -

Intermittent failure, the system is OK at this time.�