A/T Input Shaft (Mainshaft) Speed Sensor Replacement

A/T Input Shaft (Mainshaft) Speed Sensor Replacement

1. Remove the intake air duct. Service and Repair

2. Remove the air cleaner housing. Service and Repair

3. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).

4. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor in the transmission housing.

5. Check the connector for rust, dirt, or oil, and clean or repair if necessary. Then connect the connector securely.

6. Install the air cleaner housing. Service and Repair

7. Install the intake air duct. Service and Repair