Instrument Cluster / Carrier: Service and Repair

Gauge Control Module Replacement

NOTE: Before replacing the gauge control module, retrieve the ODO value and the maintenance minder information from the gauge control module with the HDS. Testing and Inspection

1. Remove the driver's dashboard undercover, Driver's Dashboard Undercover Removal/Installation then remove the dashboard lower cover. Driver's Dashboard Lower Cover Removal/Installation

2. Remove the two bolts from under the dashboard, then pull the gauge control module (A) out carefully.

3. Disconnect the 32P connector (B) from the gauge control module.

4. Install the gauge control module in the reverse order of removal.

5. Rewriting the ODO data and transfer the maintenance minder data to a new gauge control module. Testing and Inspection