Manufacturer Code Charts: 2706

Navigation System DTC Troubleshooting: 2706

DTC 2706: Gyro Diag: ECU Temp XX °C

NOTE: Before you troubleshoot, make sure to follow the general troubleshooting information. Reading and Clearing Diagnostic Trouble Codes

1. Check that the trunk temperature is between -4 °F (-20 °C) and 158 °F (70 °C).

2. Clear the hard error code. Reading and Clearing Diagnostic Trouble Codes

3. Turn the ignition switch to LOCK (0), and then back ON (II).

4. Check for the hard error code. Reading and Clearing Diagnostic Trouble Codes

Is DTC 2706 indicated?
YES - Replace the navigation unit. Service and Repair

NO - Intermittent failure, the system is OK at this time. If the unit repeatedly comes back with the DTC, replace the navigation unit. Service and Repair