Oil Spray Jet: Testing and Inspection

Engine Oil Jet Bolt Inspection

1. Remove the oil jet bolt Service and Repair.

2. Inspect the oil jet bolt as follows.

- Make sure that a 0.6 mm (0.02 in) diameter drill will go through the oil intake (0.7 mm (0.03 in) diameter). Make sure the check ball (A) moves smoothly and has a stroke of about 4.0 mm (0.16 in).
- Check the oil jet bolt operation with an air nozzle. It should take at least 120 kPa (1.2 kgf/cm2, 17 psi) to unseat the check ball.