A/T Transmission Housing Bearing Replacement

A/T Transmission Housing Bearing Replacement

Special Tools Required

- Driver 07749-0010000
- Attachment, 72 x 75 mm 07746-0010600
1. Remove the transfer output shaft bearing (A) from the transmission housing (B) by heating the housing to about 212 °F (100 °C) with a heat gun (C). Do not heat the housing more than 212 °F (100 °C).






2. Install the new bearing in the housing in the direction shown.






3. Drive the new bearing until it bottoms in the housing using the driver and the attachment (72 x 75 mm).