Reverse Idler Gear Disassembly/Inspection/Reassembly

Reverse Idler Gear Disassembly/Inspection/Reassembly

1. Remove the snap ring (A), then remove the thrust washer (B), reverse idler gear (C), needle bearings (D), and thrust washer (E) from the reverse idler gear shaft/holder (F).

2. Inspect the reverse idler gear and gear shaft for excessive wear and damage.

3. Inspect the needle bearings for galling and rough movement.

4. Install the thrust washer and needle bearings over the gear shaft.

5. Install the reverse idler gear in the direction shown.

6. Install the thrust washer, then install the snap ring to secure the idler gear.