A/T Housing Selector Control Shaft Bearing Replacement

Transmission Selector Control Shaft Bearing Replacement

Special Tools Required

- Bearing remover shaft, 10 mm 07936-GE00100
- Bearing remover head, 10 mm 07936-GE00200
- Sliding hammer weight 07741-0010201
- Driver 07749-0010000
- Attachment, 22 x 24 mm 07746-0010800
1. Remove the control shaft bearing from the transmission housing using the bearing remover head (10 mm), the bearing remover shaft (10 mm), and the sliding hammer weight.






2. Install the new bearing in the transmission housing using the driver and the attachment (22 x 24 mm).