Intermediary Shaft 4th Gear Installation

Intermediary Shaft 4th Gear Installation

Special Tools Required

- Driver, 40 mm I.D. 07746-0030100
1. Wrap the shaft splines with tape, and install the new O-rings in the 3rd clutch O-ring grooves, then remove the tape.

2. Install the 3rd clutch, 53 mm splined washer, thrust needle bearing, needle bearing, 3rd gear, and thrust needle bearing on the intermediary shaft.

3. Install 4th gear (A) using the driver (40 mm I.D.) and the press.

4. Install the 19.8 mm cotters, cotter retainer, and snap ring.

5. Install the 26.5 mm washer on the top of the intermediary shaft.