Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

1. Do the battery removal procedure. Removal and Replacement

2. Remove the air cleaner. Service and Repair

3. Disconnect the transmission fluid pressure switch A (2nd clutch) connector, and remove the switch.

4. Install the new transmission fluid pressure switch A (2nd clutch) (A) and a new sealing washer (B), and tighten the switch.

5. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

6. Install the air cleaner. Service and Repair

7. Do the battery installation procedure. Removal and Replacement