Side Airbag Cutoff Indicator Stays on After Bulb Check, and No DTCs Are Stored, or Side Airbag Cutoff Indicator Is Flashing

Side airbag cutoff indicator stays on after bulb check, and no DTCs are stored, or side airbag cutoff indicator is flashing

Diagnostic Procedure:

1. Make sure nothing is on the front passenger's seat.

2. If the side airbag cutoff indicator stays on after the ignition switch is turned ON (II), initialize the ODS unit. Programming and Relearning

3. If the side airbag cutoff indicator operates normally, the system is OK.

4. If the side airbag cutoff indicator stays on, replace the OPDS sensor. Front Seat-Back Cover Replacement The sensor is part of the seat-back pad.

Also check for:

- DTC 87-3x troubleshooting 87-3x
- Communication with the HDS