Ignition Key Light Test

Ignition Key Light Test

1. Remove the driver's dashboard undercover, Driver's Dashboard Undercover Removal/Installation and the driver's dashboard lower cover, Driver's Dashboard Lower Cover Removal/Installation then remove the steering column covers. Steering Column Removal/Installation

2. Disconnect the 10P connector (A) from the ignition switch control unit.

3. The LED should come on when power is connected to terminal No. 9 and ground is connected to terminal No. 2.

4. If the LED does not come on, faulty ignition switch control unit; replace the steering lock assembly. Service and Repair

5. Do the Ignition Switch Control Unit Registration. Testing and Inspection