Rear Crankshaft Main Bearing Seal: Service and Repair

Transmission End Crankshaft Oil Seal Installation - In Car

Special Tools Required

- Driver Handle, 15 x 135L 07749-0010000
- Driver attachment, 106 mm 070AD-RCAA200
1. Remove the transmission Automatic Transmission Removal and the drive plate. Service and Repair

2. Remove the transmission end crankshaft oil seal.

3. Clean and dry the crankshaft oil seal housing.

4. Apply a light coat of multipurpose grease to the crankshaft and to the lip of the seal.

5. Using the special tools, drive in the crankshaft oil seal until the driver attachment bottoms against the engine block end cover. Align the hole in the driver attachment with the pin on the crankshaft.

6. Clean any excess grease off the crankshaft, and check that the oil seal lip is not distorted.

7. Install the drive plate Service and Repair, and the transmission.