Front Crankshaft Seal: Service and Repair

Pulley End Crankshaft Oil Seal Installation - In Car

Special Tools Required

- Oil seal driver, 64 mm 070AD-RCAA100
1. Remove the crankshaft position (CKP) sensor, the timing belt, and the timing belt drive pulley. Service and Repair

2. Remove the pulley end crankshaft oil seal.

3. Clean and dry the crankshaft oil seal housing.

4. Apply a light coat of multipurpose grease to the crankshaft and to the lip of the seal.

5. Using the seal driver, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess grease off the crankshaft, and check that the oil seal lip is not distorted.

6. Install the timing belt drive pulley, the timing belt, and the CKP sensor. Service and Repair