Rear Door Subseal Replacement

Rear Door Subseal Replacement

NOTE:

- Take care not to scratch the door.

- Use a clip remover to remove the clips.

1. Detach the clips (A, B), then remove the lower subseal (C).

2. Remove these items:
- Door panel Rear Door Panel Removal/Installation

- Door glass outer weatherstrip Service and Repair

- Glass Service and Repair

- Quarter glass Service and Repair





3. Detach the clips (A, B, C), then remove the upper subseal (D) from the front edge of the door.






4. Pull the upper subseal (A) away from the roof portion of the door flange (B), then remove the subseal.

5. Install the subseal in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Make sure the subseal is installed in the door flange securely.