VSA System

VSA DTC Troubleshooting: 61, 62

DTC 61, 62: Low/High Voltage

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.

4. Test-drive the vehicle around a number of corners.
NOTE: Drive the vehicle on the road, not on a lift.

Does the ABS indicator come on?
YES - Go to step 5.

NO - The system is OK at this time. Refer to intermittent failures. Reading and Clearing Diagnostic Trouble Codes


5. Check for DTCs with the HDS.

Is DTC 61 or 62 indicated?
YES - Check the battery Procedures and the charging system. Alternator and Regulator Circuit Troubleshooting

NO - Do the appropriate troubleshooting for the DTC indicated.