VSA Sensor Neutral Position Memorization

NOTE: Do not press the brake pedal during this procedure

Park the vehicle on a flat and level surface, with the steering wheel in the straight ahead position
With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) under the driver's side of the dashboard

Fig 1: Identifying Data Link Connector (DLC)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II)
Make sure the HDS communicates with the vehicle and the VSA modulator-control unit If it doesn't, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING )
Select VSA ADJUSTMENT with the HDS, and follow the screen prompts
NOTE: See the HDS Help menu for specific instructions
Turn the ignition switch to LOCK (0)