Center Console Inner Box Lid Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Acura Tool and Equipment Program, call 888-424-6857

NOTE:

Take care not to scratch the center console and the related parts
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components

Remove the center console panel (see CENTER CONSOLE PANEL REMOVAL/INSTALLATION )
Disconnect the rear accessory power socket connector, the auxiliary jack assembly connector, and the USB jack connector (see step 2 on page 20-113)
Open the console armrest
Remove the console box mat (A)
NOTE: It may be easier to use packing tape to remove the mat

Fig 1: Identifying Console Box Mat
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then open the lid (A) by prying the hooks (B) with the appropriate trim tool

Fig 2: Opening Lid
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pivot the Inner box lid (A) up on the upper hooks (B) to detach the lower hook (C), then remove the lid from the console box (D)

Fig 3: Identifying Lid From Console Box
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the lid in the reverse order of removal