Hazard Warning Switch Test/Replacement

Remove the audio-navigation switch panel^*1 (see AUDIO-NAVIGATION SWITCH PANEL REMOVAL/INSTALLATION ) or audio unit^*2 (see AUDIO UNIT REMOVAL/INSTALLATION )
* 1 With navigation

* 2 Without navigation
Disconnect the 5P connector (A) from the hazard warning switch (B)

Fig 1: Identifying 5P Connector Terminals And Hazard Warning Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the two screws and the hazard warning switch
Check for continuity between the terminals in each switch position according to the table

Fig 2: Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the hazard warning switch
Install the switch in the reverse order of removal