Automatic Dimming Inside Mirror (4-CYL): Test/Replacement
- Remove the cover (A), then disconnect 7P connector (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Turn the ignition switch to ON (II)
- Measure the voltage between terminal No 2 and body ground
- If there is less than 0 5 V, go to step 4
- If there is more than 0 5 V, check for
- An open in the wire
- Poor ground (G 501)
- Measure the voltage between terminal No 1 and body ground
- If there is battery voltage, go to step 5
- If there is no voltage, check for
- Blown No 5 (7 5 A) fuse in the driver's under-dash fuse/relay box
- An open in the wire
- Measure the voltage between terminal No 3 and body ground with the shift lever in R (reverse) position
- If there is battery voltage, replace the mirror assembly
- If there is no voltage, check for
- An open in the wire
- Faulty driver's under-dash fuse/relay box
- Faulty transmission range switch (A/T)
- Faulty back-up light switch (M/T)