Ceiling Light Test/Replacement
- Turn the ceiling light switch OFF
- Carefully pry the lens (A) off with a small screwdriver
Ceiling Light 8 W
- Remove the screws, then remove the ceiling light (B)
- Disconnect the 3P connector (C) from the ceiling light
- Check for continuity between the terminals
- There should be continuity between terminals No 1 and No 2 with the switch in the MIDDLE (DOOR) position
- There should be continuity between terminals No 2 and No 3 (body ground) with the switch in the ON position
- There should be no continuity between terminals No 1 and No 2, and between terminals No 2 and No 3 (body ground) with the switch in the OFF position
- If the continuity is not as specified, check the bulb If the bulb is OK, replace the ceiling light
- Install the light in the reverse order of removal