Side Sill Protection Tape Replacement

1. Slowly peel up the old side sill protection tape
2. Clean the body bonding surface with a shop towel dampened in isopropyl alcohol After cleaning, keep oil, grease, and water from getting on the surface
3. Peel off adhesive backing A from the side sill protection tape (C)
   NOTE: Do not peel adhesive backing B
Fig 1: Identifying Adhesive Backing From Side Sill Protection Tape
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Align the edge of the side sill protection tape (C) with the radius tangent line (D) in the body, and align the edge of adhesive backing B with the convex portion (E) of the body, then press the side sill protection tape where adhesive backing A was removed into place
   Fig 2: Aligning Edge Of Side Sill Protection Tape With Radius Tangent Line

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Remove adhesive backing B from the side sill protection tape (A), and press the tape into place

Fig 3: Identifying Adhesive Backing From Side Sill Protection Tape

Courtesy of AMERICAN HONDA MOTOR CO., INC.