Roof Molding Replacement

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the Acura Tool and Equipment Program, call 888-424-6857

1. Apply protective tape (A) to the body. Using a trim tool, pry up on the roof molding (B)
   Fig 1: Identifying Roof Molding

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Pull up and slide the roof molding to release the front bracket (C) from the pin (D), then remove the roof molding from under the windshield molding (E)
3. Pull up the front portion of the roof molding (A)
   Fig 2: Identifying Front Portion Of Roof Molding

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Pull up and release the rear bracket (A) from the pin (B), then remove the roof molding (C)
   Fig 3: Identifying Roof Molding

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Install the molding in the reverse order of removal, and note these items

• Take care not to damage the windshield molding
• Make sure the roof molding is installed securely

Fig 4: Identifying Roof Molding Installation Position

Courtesy of AMERICAN HONDA MOTOR CO., INC.