Driver's Dashboard Undercover Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to scratch the dashboard and related parts.

Remove the driver's dashboard undercover (A).
1. Gently pull down the front edge to detach the clips (B, C).
2. Disconnect the ambient light connector (D).
3. Pull the cover away to release the pin (E) from the holder (F).
Fig 1: Identifying Driver's Dashboard Undercover, Ambient Light Connector, Pin And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the holder of the cover is installed securely to the pin.